*
new
The process of wave erosion is a relatively
phenomenon on Earth.
10 points
о
True
о
False
The answer fam is......... False
10 POINTS
Which tool can be used to measure the volume of a liquid to one decimal place?
Options:
a beaker
a graduated cylinder
an Erlenmeyer flask
a test tube
what is atomic radius
Explanation:
The atomic radius of a chemical element is a measure of the size of its atoms, usually the mean or typical distance from the center of the nucleus to the boundary of the surrounding shells of electrons. Since the boundary is not a well-defined physical entity, there are various non-equivalent definitions of atomic radius. Three widely used definitions of atomic radius are: Van der Waals radius, ionic radius, and covalent radius
Neturally an atom is neutral in charge why
Answer
Explanation:
an atom is usually define as a perfect balance of electrons and protons
Insoluble substances can dissolve in all solvents
True or false
Answer:
Not all substances dissolve in all solvents
Explanation:
In chemistry, a common rule for determining if a solvent will dissolve a given solute is "like dissolves like." Solvents composed of polar molecules, such as water, dissolve other polar molecules, such as table salt, while nonpolar solvents, such as gasoline, dissolve nonpolar substances such as wax. Some substances are strong enough to not dissolve.
Please can I have help on these two questions I’ll be very grateful!!!!!!
Answer:
-1 IS THE CHARGE OF ELECTRON AS THEY ARE NEGATIVE
MARK ME AS BRAINLIEST IF U FOUND IT HELPFUL
Select the measurement with that represents the least amount of pressure.
Select one:
a. 3 atm
b. 3.039 x 1013 Pa
c. 2.280 x 10^3 mm Hg
d. 40 psi
Answer:
a 3atm
Explanation:
or d 40 psi because it is true and corect [b 3.0398 21oinwex id cn uerfh uh 837hf uxhoec
d.
both a
5. It dissolves more substances than any other?
a. sugar
b. salt
c. water
d. pebble
salt
Explanation:
I hope this answer is right
A helium-filled balloon is released into the atmosphere. As the balloon rises, which
would MOST likely increase and cause the balloon to burst?
O the volume of the helium
O the mass of the helium
o the temperature of the helium
O the density of the helium
I WIl GIVE YOU BRAINLIEST
Answer:
"A" i'm pretty sure
Hope this helps
Theorists try to find ways to explain human behavior in rational ways. It seems irrational to break rules, if we want to maintain social order. We are largely constrained by the rules and obliged to behave in a particular way or to avoid certain behaviors. What motivates people to break social rules? Do you think powerful and famous people tend to break more rules? Is it worth breaking these rules? No Response(s) Be the first to respond to the Discussion topic!
Answer:
See explanation
Explanation:
According to Burgess (1996); 'We don't break rules because it 'doesn't feel right' to do so. Some elements of personality can determine whether we will break rules or not, particularly when the moral/social-conventional distinction is taken into consideration'.
If an individual has the urge to behave in a manner that transgresses social rules, personality characteristics now come into play here. Personality traits determines whether the individual considers him/herself as bound by the rules. Some people will follow the rules absolutely while some only follow rules that they consider important, a small proportion will not follow any rule that prevents them from achieving their set objectives.
Famous people become carried away with affluence and position and tend to break more rules since they believe that they will always get away with it because of whom they are.
Irrespective of the circumstances, it is never worth it to break a rule. We always have to see ourselves as bound by rules as part of our social responsibility.
A piece of metal that has a density of 5.2 g/cm3 and a mass of 100 g was placed in a full jar of water. How many mL of water was spilled out of the jar? Note: one cm^3 = one mL
Answer:
100g / (5.2g/cm3)
= 100g / (5.2g / 1cm3)
= 100g x 1cm3 / 5.2 g
= 19.2 cm3
Since 1 cm3 = 1 ml, your answer is 19.2 ml.
The given density and mass of the metallic piece can be used to estimate the volume of the substance. The metal with a mass of 100 gm and a density of 5.2 g/cm³ has a volume of 19.23 ml.
What is the relation between density and volume?The density of the substance has been given by the ratio of mass to the volume of the substance in g/cm³ or g/mL. It shows the packaging of the molecules in the substances and has been in inverse relation to the volume.
The mass being constant and an increase in volume decreases the density of the substance and vice versa. The volume can be calculated as:
Volume = mass ÷ density
Given,
Density of the metal (ρ) = 5.2g/cm³
Mass of the metal piece (m) = 100g
Volume = V
Substituting the values above as:
ρ = m ÷ V
V = m ÷ ρ
V = 100 ÷ 5.2
= 19.23 mL
Therefore, 19.23 mL is the volume of water that spilled out of the jar.
Learn more about volume and density, here:
https://brainly.com/question/13799762
#SPJ2
True or False: A Precipitate is a solid
that forms out of a liquid solution as a
result of a chemical reaction
Answer:
true because it undergoes a tranformation
Explanation:
describe how the current modern atomic theory and model differs from the model jj Thompson proposed ?
How do covalent bonds form?
By what process do small molecules move into cells?
Answer:
small molecules move into the cell, Then it is by diffusion or facilliated diffusion.
True or false
Each family represents the number of energy levels present in an atom of the element.
Answer:
true because of the elements
What is the correct name for the compound P406?
A. Phosphoric acid
B. Tetraphosphorus hexoxide
C. Phosphorus (IV) oxide
D. Phosphorus oxide
Answer:
Phosphorus trioxide
Explanation:
Answer:
Tetraphosphorus hexoxide
Explanation:
Give brainliest please
The boiling of soy oil determined by a student in the laboratory turned out to be 319.5 oC. The accepted value of this melting point is 300 oC. What is the percent error in this reading?
Answer:
Percent error = 6.5%
Explanation:
Given data:
Measured value = 319.5°C
Accepted value = 300°C
Percent error = ?
Solution:
Formula:
Percent error = measured value - actual value / actual value × 100
Now we will put the values in formula.
Percent error = 319.5°C - 300°C/300°C × 100
Percent error = 19.5 °C /300°C × 100
Percent error = 0.065× 100
Percent error = 6.5%
What is the specific heat of a metal if the temperature of a 12.5 g sample increases from 19.5 C to 33.6 C when it absorbs 37.7 J of heat.
Answer:
0.213 J/g°C
Explanation:
To calculate specific heat of the metal, the formula is used:
Q = m × c × ∆T
Where Q = amount of heat
m = mass
c = specific heat
∆T = change in temperature
According to this question, Q = 37.7 J, m= 12.5 g, initial temperature= 19.5 °C, final temperature = 33.6°C, c=?
Q = m × c × ∆T
37.7 = 12.5 × c × (33.6-19.5)
37.7 = 12.5c × 14.1
37.7 = 176.25c
c = 37.7/176.25
c = 0.2139
Hence, the specific heat of the metal is 0.213 J/g°C
Which quantum number describes the orientation of an orbital within a sublevel?
Explanation:
Each orbital within a particular sublevel is distinguished by its value of ml. This quantum number may be more aptly named the orbital orientation quantum number. In each energy sublevel (designated by l) there are 2l+1 possible independent orientations of the electron cloud.
Answer:
[tex]m_l-magnetic[/tex]
Explanation:
The principal energy level, n, tells us which shell it is in and the total energy of the electron.
The angular momentum (azimuthal), l, tells us which sublevel/subshells the electron is in.
The magnetic, m sub l, tells us the orientation the electron is spinning.
What is the correct order of increasing elec-
tronegativity?
1. Si, P, S, C, N, O, F
2. O, C, N, S, P, Si, F
3. F, Si, P, S, N, C, O
4. F, O, N, C, S, P, Si
Answer:
ceo que3
Explanation:
What is true about the formation of a bond?
Answer:
There is an overall release of energy when bonds form.
Explanation:
There is a general release of energy when bonds form. This energy is called bond energy.
Bond energy is involved in the breakdown or formation of one or more bonds between atoms of a molecule. Atoms bond with each other to achieve their electronic stability, that is, they move from a higher energy situation to a lower energy one. With this we can state that when the bond between atoms is formed, energy is released; therefore, its breakdown depends on energy absorption.
what is the average distance between the sun and earth in summer and winter
Answer:
93,000,000 miles (8.5 light minutes)
Explanation:
In the northern hemisphere's winter, the earth is slightly closer to the sun than in the southern hemisphere's winter season
Destructive forces can include floods, landslides, tornadoes, tsunamis, wildfires and
volcanoes.
True
False
Answer:
answer is true
Answer:
True
Explanation:
please hurry i’m taking a test
Answer:
im pretty sure its move at a constant rate to the right
Which of the following elements has the lowest electronegativity?
A. Barium
B. Magnesium
C. Strontium
D. Calcium
Answer:
A. Barium
Explanation:
hope this helps! :)
combined aggregation of minerals
Answer:
Rocks
Explanation:
The combined aggregation of minerals are called rocks. There are three types of rocks Igneous Rocks, sedimentary rock, and metamorphic rocks.
Rocks are formed due to the repetitive, orderly, geometrical internal arrangement of minerals. Minerals undergo several processes such as weathering, crystallization, erosion, and sedimentation to form rocks.
Hence, the combined aggregation of minerals is called rocks.
Which RNA strand would match with this DNA strand?
AGGCTAAT
What is the DNA strand? You have not named it.
Once upon a time, Walter the water molecule was traveling around Linda's blood. He was enjoying moving around wherever he wanted. One day, Walter decided to visit some cells. He traveled in and out of the cells as he pleased. Walter decided that he liked the cells so much that he wanted to stay inside and rest in the vacuole. However, as the day went on, Walter felt a change happening around him. Linda had eaten some VERY salty popcorn. Walter LOVED Sally the salt molecule and felt a magnetic attraction to her. The closer the salt came to the cell, the quicker Walter's love for Sally pulled him out of the cell and towards the salt.
Answer:
This story that is related to the movement of water in relation to the amount of solute seeks to explain the process of OSMOSIS in a very interesting way.
Explanation:
The OSMOSIS process is a process where water diffuses from a compartment with fewer solutes to one with higher solutes, that is why the osmotic intention is to balance the concentrations and molarities between both compartments, this is called osmotic balance.
For this to happen, a highly water-permeable barrier is needed.